Fitted aileron pocket ribs on both wings. This was a pain in the ass. Install the pocket ribs on the work bench before putting the rear spars in the wing fixture.

Installed and aligned strut aileron cable pulleys on both wings.

Install root end flap tube support bearings on both wings.

Fitted aileron pulley at strut on left wing.

Welded flap drive steel parts.

Disassembled false spars, deburred, primed, and riveted.

Fabricated fuel tank strap mounts, drilled and fitted on false spar.

Riveted nose ribs on right wing.

Riveted nose ribs on left wing.

Riveted center ribs on right wing

Riveted center ribs on left wing.

Fabricated right wing false spar and false spar and short rib attach angles.

Fitted short ribs and fabricated left wing false spar.

Removed center ribs and nose ribs, deburred and reinstalled.

Installed Left wing nose ribs.

Installed center ribs on left wing.

Finished right wing nose rib installation. Set left wing rear spar in fixture.

Installed half of right wings nose ribs.

Installed right wing center ribs.

Squared and leveled right wing in jig

Constructed wing assembly frame.

Welded left wing flap and aileron drive linkage.

Welded right wing flap and aileron drive linkage.

Fabricated wing end strut fittings.

Finished fuselage wing strut fittings.

Fabrcated aileron cable pulley brackets and started on fuselage wing strut fittings.

Fabricated aileron hinges and flap support at wing root.

Fabricated flap levers.

Fabricated flap drive arms.

Fabricated pieces for aileron bellcranks.

Fabricated aileron and flap drive support frame components.

Fabricated aileron and flap drive support brackets.

Riveted left rear spar rib attach angles.

Removed rib angles and spacers from left rear spar, de-burred prepared for paint and primed.

Fitted rib attach angles and spacers to left rear spar.

Assembled left rear spar,riveted cap strips and wing attach fittings.

Cut left rear spar root and tip ends to length. Cut lightening holes. De burred and prepared for paint spar web, cap strips, and wing attach fittings. Painted all.

Drilled cap strips, center splice plates, and attach fittings to left rear spar web.

De-burred left rear spar cap strips. Fabricated attach angle spacers.

Marked out rib and station positions on left rear spar. Drilled cap strips.

Painted right rear spar rib attach angles and spacers. Riveted angles to spar.

Fitted spacer bars and rib angles to right rear spar.

De burred rib attach angles and spacers. Fitted a few rib attach angles to right rear spar.

Riveted right rear spar cap strips. Cutout rib attach angles for rear spar

Assembled cap strips on right rear spar and prepared for riveting.

Trimed root end of right rear spar.
Cut cap strips to length.
De burred spars, cap strips, and attachment fittings.
Painted all.

Drilled cap strips and wing attach fittings to right rear spar.
Cutout center splice plates.

De burred right rear spar cap strips.
Cut rib spacers and drilled.

Marked right rear spar cap strips and drilled.

Riveted right wing spar angles.
Marked out right rear spar stations and ribs.

Removed rib attach angles from right main spar, de-burred and painted

Removed left main spare rib attach angles, de-burred and painted.
Riveted left main spar rib angels.